How do I reset the WaterGuru SENSE S1?

SENSE S1 Reset

Follow these steps to reset the SENSE S1 device and reconnect it to your Wi-Fi network

Note: The reset does not remove the Wi-Fi network SSID and password which are stored in the SENSE

1. Take the device out of the skimmer
2. Take the device into an area either indoors or close to the pool that is shaded, so you can see the battery lights upon boot-up
3. Place the device on a flat surface and push down on the outer ring to open the device
4. Remove all 4 batteries and wait about 30 seconds - to allow full discharge 
5. After 30 seconds, replace all 4 batteries and observe the multi-colored lights on the side of the top skimmer lid that will blink on and off for several seconds and then stop.  If you don't see the lights, replace the batteries with new batteries and/or ensure you have waited 30 seconds to allow full discharge.
6. The device is now broadcasting it's BLE Bluetooth Low Energy address
7. Close the battery compartment
8. Force close the WaterGuru app on your phone if it is running
9. On your phone, disable Bluetooth
10. On your phone, enable Bluetooth
11. Launch the WaterGuru App

If you have made no changes to your original Wi-Fi network, your device should connect to the network again and will be online.  You can place the SENSE device back in the skimmer.

Wait 30 minutes and you then you can check the SENSE connection status in your app.  

• Launch the WaterGuru app
• Tap the Gear icon (Settings)
• Tap Device Info > Last Connection
• Last Connection is an indication of the last time your SENSE connected to your home Wi-Fi network. The SENSE device checks the water temperature every 30 minutes so the Last Connection time is updated every 30 minutes.
• 

If you have made changes to your Wi-Fi network, i.e. new password, new Wi-Fi router, etc., you will need to tap Settings > Wi-Fi settings to switch the SENSE to the new network.

Note:  There is no Factory Reset option for the SENSE, nor is it necessary. The SENSE receives regular Firmware updates that are delivered OTA - Over the air - through Wi-Fi to keep the device software up-to-date.  

Light Sequence by SENSE S1 model

SENSE S1 - 2022 - 2023 generation

• The lights in the top skimmer lid will blink on and off red and green and then stop

SENSE S1 - 2020 - 2022 generation

• The lights in the top skimmer lid will blink on and off red, green and blue and then stop