WaterGuru TREAT Unboxing and Setup
Follow the steps below to unbox and set up your WaterGuru TREAT
Remove the WaterGuru TREAT from the box and open the TREAT Lid
- Remove the TREAT from the box and place it on a flat surface
- Press in the tab on the top back of the TREAT to release the top lid.
- Lift and remove the lid
Remove the TREAT housing
- Unscrew the Drop pH tube from the lid and set the lid aside
- Lift the embedded C-shaped handle to its fully opened position
- Move the two J-shaped housing locks to the inner unlocked position
- Pull straight up to remove the outer housing
Add the TREAT Batteries
- Open the Battery Compartment Latch
- Insert new batteries maintaining + or - polarity orientation. If the battery polarity is not correct, the device will not power on.
- Close the Battery Compartment Latch firmly
Add the TREAT Cassette
- Open the Cassette Latch
- Replace/insert a new Cassette in the same orientation
- Close the Cassette Latch firmly
Download the WaterGuru App and create an Account
- Launch Google Play or Apple App Store
- Download and install the WaterGuru App
- Create a WaterGuru account
Activate the WaterGuru TREAT
- Follow the in-App instructions to Activate TREAT, add your pool and -air your WaterGuru TREAT with your Wi-Fi network
- Note: If you experience any issues pairing your device, do not proceed with adding chemicals - Contact WaterGuru Support for assistance
Add WaterGuru Cal Hypo
- Flip open the Cal Hypo Tank Door
- Cut just the corner of the Cal Hypo bag to open
- Insert the edge of the bag into the Cal Hypo tank, and let the Powder flow into the Tank
- Fill the Cal Hypo up to the bottom of the Black Mark on the Auger Shaft
- After filling the tank, press and firmly close the Cal Hypo Door
Add WaterGuru Drop pH
- Keep the Acid Fill Tube up straight
- Open the 1 Gallon Drop pH Acid bottle, remove the seal
- Securely screw the top of the WaterGuru TREAT Acid Fill tube to the top of the Acid bottle
- Ensure that the WaterGuru TREAT Acid Fill tube is attached securely to the Acid bottle
- Lift up the Acid bottle
- Hold up the bottle to fill
- Once the bottle is emptied, put the acid bottle down, make sure no Acid Liquid is inside the Acid Fill Tube
- Unscrew the acid bottle from the WaterGuru TREAT Acid fill tube
- Replace the Acid fill tube upright in the WaterGuru TREAT
- Screw the Acid Fill Tube on to the lid. Make sure it is screwed tightly and securely.
Replace the TREAT Housing
- Install the outer housing, carefully watch the orientation so the housing latches are both aligned
- Move the two J-shaped housing latches to the outer locked position
Place on Skimmer and Install the Lid
- Remove existing skimmer cover
- Using the handle, lift and place the TREAT centered over the skimmer opening
- Push the C-shaped handle down to its closed position.
- Install the Lid, inserting the lower end first and then the higher end
Welcome to your hassle-free pool care
Comments
0 comments
Article is closed for comments.