How do I fill the WaterGuru TREAT Cal Hypo Tank?

When it is time to add Cal Hypo to your WaterGuru TREAT, the following message will be displayed in the App:  Refill Chlorine Now.  This message is an indication that there is 5% of Chlorine remaining.

When you see this message follow the steps below:

Fill the WaterGuru TREAT Cal Hypo tank

1. Press in the tab on the back of the TREAT to release the top lid 
2. Lift the lid and let it hang down from the side of the TREAT. 
3. Lift the C-shaped handle to its fully opened position
4. Using the handle, lift the TREAT to remove it from the Skimmer
5. Place the TREAT on the pool deck
6. Locate the cream-colored circular lock on the top of the TREAT which is used to lock / unlock the Cal Hypo Tank Cover
7. Move the circular lock to the unlocked position
8. Using the 2 "wings" on either side of the Tank Cover, flip open the Cal Hypo Tank
9. Cut just the corner of the Cal Hypo bag to open
10. Insert the edge of the bag into the Cal Hypo tank, and let the Powder flow into the Tank
11. Filling amount - During pool season, fill the Cal Hypo up to below the top black line mark on the Auger Shaft.  During non-pool season, fill the Cal Hypo until few inches below the black line mark on the Auger Shaft.
12. Take note on how many bags you have added.  You will need to enter this information into the App.  Step #20 below.
13. After filling the tank, press and firmly close the Cal Hypo Tank Cover
14. Move the circular lock to the locked position to lock the Cal Hypo Cover
15. Using the handle, move the WaterGuru TREAT from the flat surface to the skimmer
16. Close the handle so that it is flush with the top of the TREAT
17. Close the Lid, inserting the lower end first and then the higher end
18. Note:  Rinse the empty Cal Hypo bags in the pool water, then you can throw the bags away.

Update Supply Levels in the WaterGuru App

1. Launch the WaterGuru App
2. Tap on Supply Levels from the carrousel menu in the lower portion of the screen
3. Tap on Granular Chlorine
4. Tap on Unlock and add
5. Tap Save & Continue through the steps until you reach Fill tank
6. Move the slider over to the number of bags, you have entered.  
7. Tap Save & Continue
8. Tap Yes at the Is the Latch Closed screen
9. Tap Save & Continue
10. You are done!