How do I replace WaterGuru TREAT batteries?
When it is time to replace the WaterGuru TREAT batteries, the following messages will be displayed in the App:
- Replace Batteries Soon. This message is an indication that there is 33.3% battery strength left
- Replace Batteries Now. This message is an indication that there is 16.7% battery strength left
Follow these steps to replace the WaterGuru TREAT batteries:
- Press in the tab on the back of the TREAT to release the top lid
- Lift the lid.
- Unscrew the Drop pH tube from the lid and keep the Acid Fill Tube up straight
- Set the lid aside
- Lift the C-shaped handle to its fully opened position
- Using the handle, lift the TREAT to remove it from the Skimmer
- Place the TREAT on the pool deck
- Move the two J-shaped housing locks to the inner unlocked position
- Pull straight up to remove the outer housing
- Open the Battery Compartment Latch
- Insert new batteries maintaining + or - polarity orientation. If the battery polarity is not correct, the device will not power on.
- Close the Battery Compartment Latch firmly
- Install the outer housing, carefully watch the orientation so the housing locks are both aligned
- Close the housing locks
- Using the handle move the WaterGuru TREAT from the pool deck to the skimmer
- Close the handle so that it is flush with the top of the TREAT
- Screw the Acid Fill Tube on to the lid. Make sure is closed tightly and securely
- Close the Lid, inserting the lower end first and then the higher end
Comments
0 comments
Article is closed for comments.