How do I replace the WaterGuru SENSE batteries?
When it is time to replace the WaterGuru SENSE batteries, these messages will be displayed in the App:
- Replace Batteries Soon - This is an indication that there is 33.3% battery strength left
- Replace Batteries Now - This is an indication that there is 16.7% or less battery strength left
Follow these steps to replace the WaterGuru SENSE batteries:
SENSE Gen 2 Battery Replacement
- The Battery compartment is located within the inner section of the WaterGuru SENSE skimmer cover.
- Remove SENSE from your skimmer.
- Wipe away all the moisture with a cloth. It’s important to keep moisture out of the battery compartment to avoid corrosion.
- Place the unit on a dry towel on a flat surface, logo side up, and firmly press down on the outer ring (see the video below). Note: It does take a very firm downward press to break the vacuum seal to separate the outer ring.
- The outer ring will disengage from the inner part of the unit, revealing the waterproof battery compartment.
- Place the inner part logo side down. Remove the old batteries. Safely dispose of the batteries.
- Insert 4 new C size batteries from recommended brand.
- Reconnect the inner part with the outer part. Press together firmly to ensure both sections are fully connected.
- Ensure that the tether cable is not sandwiched between the two parts, you can do that by pulling the cable through to bring the two parts together.
- The batteries are secured when the two parts are engaged. (The small gap between the two parts is a design feature and not a defect.)
- The top LED light will flash indicating that unit has turned on.
- Place the lower Cassette / Sensor unit (inside the mesh bag) back in the skimmer with the SENSE cover on top of the skimmer.
SENSE Gen 1 Battery Replacement
- The Battery compartment is located within the inner section of the WaterGuru SENSE skimmer cover.
- Remove SENSE from your skimmer.
- Wipe away all the moisture with a cloth. It’s important to keep moisture out of the battery compartment to avoid corrosion.
- Place the unit on a dry towel on a flat surface, logo side up, and firmly press down on the outer ring (see the video above).
- The outer ring will disengage from the inner part of the unit, revealing the waterproof battery compartment.
- Place the inner part logo side down. Remove the old batteries. Safely dispose of the batteries.
- Insert 4 new C size batteries from recommended brand.
- Reconnect the inner part with the outer part. Press together firmly to ensure both sections are fully connected.
- Ensure that the tether cable is not sandwiched between the two parts, you can do that by pulling the cable through to bring the two parts together.
- The batteries are secured when the two parts are engaged. (The small gap between the two parts is a design feature and not a defect.)
- The top LED light will flash indicating that unit has turned on.
- Place the lower Cassette / Sensor unit (inside the mesh bag) back in the skimmer with the SENSE cover on top of the skimmer.
Comments
0 comments
Article is closed for comments.